tp-link RE450 doesnt work anymore
Hi. I'm located in Italy and after successfully installed and connected my tp-link after 6 months it doesnt work anymore. I use tp-link to extend the wi-fi of my home owner on my phone and pc. It always worked until today. Internet on both devices simply stop working and when i try to connect again it shows "Internet not available" I checked if was the main router but its not, on the app on the phone doesn't show me any error or problem to my understanding. I try also to completely reset again tp-link installing from the start. it show me that is ok and extending the wi-fi but my devices can't connect it.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Matildee
If your client devices have no Internet access when connected to the Range Extender's Wi-Fi, check the LED status on the extender and refer to the situations below to troubleshoot:
Situation One: Signal/2.4G/5G lights are all off or signal light is red.
1). Ensure the extender is within the Wi-Fi range of the host router. Move it closer to the router.
2). Restart the router and the extender.
3). Hard reset the extender and reconfigure it.
Situation Two: Signal/2.4G/5G lights are on:
1). Ensure the router's Wi-Fi is working properly.
2). Restart the router and the extender.
3). Upgrade the extender's firmware to the latest.
4). Turn off any Mac address filter or Access Control feature on the host router. Please contact the router support for detailed instructions.
5). Compare the IP address obtained from the router and the extender. If they are not in the same network segment, enable the DHCP server on the extender. Check this link for detailed guidance: If my TP-Link range extender can't connect to my router properly
Situation Three: Only one device/client cannot access the Internet
1). Reboot the device and the extender.
2). Try connecting the device to a different Wi-Fi network to ensure it works.
3). Update the network adapter of the device.
- Copy Link
- Report Inappropriate Content
Hi @Matildee
If your client devices have no Internet access when connected to the Range Extender's Wi-Fi, check the LED status on the extender and refer to the situations below to troubleshoot:
Situation One: Signal/2.4G/5G lights are all off or signal light is red.
1). Ensure the extender is within the Wi-Fi range of the host router. Move it closer to the router.
2). Restart the router and the extender.
3). Hard reset the extender and reconfigure it.
Situation Two: Signal/2.4G/5G lights are on:
1). Ensure the router's Wi-Fi is working properly.
2). Restart the router and the extender.
3). Upgrade the extender's firmware to the latest.
4). Turn off any Mac address filter or Access Control feature on the host router. Please contact the router support for detailed instructions.
5). Compare the IP address obtained from the router and the extender. If they are not in the same network segment, enable the DHCP server on the extender. Check this link for detailed guidance: If my TP-Link range extender can't connect to my router properly
Situation Three: Only one device/client cannot access the Internet
1). Reboot the device and the extender.
2). Try connecting the device to a different Wi-Fi network to ensure it works.
3). Update the network adapter of the device.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 83
Replies: 1
Voters 0
No one has voted for it yet.