Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > P7 Powerline Backhaul PLC

< Deco

P7 Powerline Backhaul PLC

KonradP

Yesterday

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-11-14

P7 Powerline Backhaul PLC

Yesterday

Tags: #Network Connectivity #Firmware Update

Model: Deco P7

Hardware Version:

Firmware Version: 1.4.11 and 1.4.10

Hi,

recently PLC connection stopped working properly. I have one P7 which needs to use PLC instead of WiFi. Now the device is choosing Wifi with very weak signal instead choosing PLC which could provide right quality. Which means my connected devicea re dropping and connecting again all the time. It makes me crazy as I receive hundreds messages about that.

I have checked this on 1.4.11 and also on downgarded 1.4.10 firmware. The same behaviour.

Is there any chance to set PLC as a default? Ot any other solution to set PLC as preferred connection?

2 Reply

Marvin_S

14 hours ago

Posts: 1780

Helpful: 129

Solutions: 197

Stories: 0

Registered: 2022-05-09

Re:P7 Powerline Backhaul PLC

14 hours ago

@KonradP

Hi, thanks for posting question here.

When did you purchase the Decos? It is suggested to reboot all Decos for a try.

You may also relocate Decos to confirm whether Powerline backhaul reworks.

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.

KonradP

LV1

11 hours ago

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-11-14

Re:P7 Powerline Backhaul PLC

11 hours ago

Hi @Marvin_S

I have purchased couple of years ago and till now there was no problems in my decos setup. You can imagine in the meantime I restarted all many times. As I have read somewhere in the community, I have downgraded firmware to 1.4.10 and now it looks better. The deco where I expect PLC now is connected through it. So the question is what happened in 1.4.11 firmware versions that are causing such issues for me and other users - as I read in the forum.

P7 Powerline Backhaul PLC

P7 Powerline Backhaul PLC

Information

Voters 0

Tags