DECO E4 Can't link second Deco device in AP mode

David-TP

2024-10-22 03:32:46

Posts: 12776

Helpful: 1790

Solutions: 1294

Stories: 9

Registered: 2020-04-14

Re:DECO E4 Can't link second Deco device in AP mode

2024-10-22 03:32:46

@Kaui

Hi, When Deco E4 works in router mode, only the main Deco will obtain an IP address from the ISP router. But in AP mode, both units will get IP addresses from the ISP router.

Have you tried to temporarily disable the MAC Filtering or also add the MAC address of the satellite E4 to the Allow List?

Thank you very much and wait for your reply.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.

0

#2

Kaui

LV1

2024-10-22 03:51:29

Posts: 3

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2024-10-21

Re:DECO E4 Can't link second Deco device in AP mode

2024-10-22 03:51:29

Hi ! Thank you for your support. There is no MAC Filtering in AP mode and I already disable it when I start setting up. The first one I tried is to Setup the main DECO E4 in Router mode and connect other 2 E4. It's working but I don't have a security. So I switch the Main E4 to AP mode, then the other 2 E4 disconnected, all 3 E4 mac address is registered in the ISP Router. Right now I can't see mac filtering settings in AP mode, the only settings that showing are 1. Operation Mode 2. Smart DHCP - Disabled ( I tried to Enable this but still no connection to others.) 3. Fast Roaming - Disabled 4. Beamforming - Enabled Thank you again.

0

#3

Kaui

LV1

2024-10-22 03:51:30

Posts: 3

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2024-10-21

Re:DECO E4 Can't link second Deco device in AP mode

2024-10-22 03:51:30

Hi ! Thank you for your support. There is no MAC Filtering in AP mode and I already disable it when I start setting up. The first one I tried is to Setup the main DECO E4 in Router mode and connect other 2 E4. It's working but I don't have a security. So I switch the Main E4 to AP mode, then the other 2 E4 disconnected, all 3 E4 mac address is registered in the ISP Router. Right now I can't see mac filtering settings in AP mode, the only settings that showing are 1. Operation Mode 2. Smart DHCP - Disabled ( I tried to Enable this but still no connection to others.) 3. Fast Roaming - Disabled 4. Beamforming - Enabled Thank you again.

1

#4

DECO E4 Can't link second Deco device in AP mode

DECO E4 Can't link second Deco device in AP mode

Information

Voters 0

Tags