m4 3 pack deco v2 - child deco after power up blinks red light
main deco connected ok to the internet.
child deco after power up and initial continuous yellow light , then it starts blinking red . Cannot reset the child deco.
I also put child deco close to the main but the red blinking light persists.
Can some help?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
Did you just purchase the current Deco units?
"Cannot reset the child deco."
- Do you mean the LED couldn't turn flashing blue?
- Will this satellite Deco still broadcast a default SSID, such as Deco_xxxx(the last 4 letters of the MAC address)?
Please also refer to this link to check whether it could get into firmware recovery mode:
How to use firmware recovery if the Deco become brick
Thank you very much and wait for your reply.
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
Did you just purchase the current Deco units?
"Cannot reset the child deco."
- Do you mean the LED couldn't turn flashing blue?
- Will this satellite Deco still broadcast a default SSID, such as Deco_xxxx(the last 4 letters of the MAC address)?
Please also refer to this link to check whether it could get into firmware recovery mode:
How to use firmware recovery if the Deco become brick
Thank you very much and wait for your reply.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 92
Replies: 1
Voters 0
No one has voted for it yet.