TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection
TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection
2024-10-09 21:14:18 - last edited Yesterday
Model: TX201  
Hardware Version: V1
Firmware Version: 10.56.119.2022

I've installed a TX201 adaptor in my PC (the onboard is a 100/1000 port) thinking I'd take advantage of improved speed of my home network (TP-link Deco BE65, 2.5GbE ports) and internet connection (2000/2000 fibre connection), but doing a speed test now shows I'm now getting 450/450Mbps, whereas previously I was getting 950/700Mbps. This effect is visible by running speed tests one after the other and swapping the ethernet cable between the ports.

 

The TX201 is showing that the network is a 2.5GbE connection, so I'm not sure what's going on. Any suggestions?

 

I should note that I tried running a speed test on measurementlab and using the onboard ethernet I get retransmission rates <0.3%, but using the TX201 I get a retransmission rate >25%

  0      
  0      
#1
Options
1 Accepted Solution
Re:TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection-Solution
2024-10-13 09:54:48 - last edited Yesterday

  @Patar 

Hi,

 

Is it directly connected to the main Deco?

Please also provide the following information for us to check:

1. The network topology.

2. The screenshots of the speed test results and the retransmission rate result.

3. The specification of your Ethernet cable and the computer operation system.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection-Solution
2024-10-13 09:54:48 - last edited Yesterday

  @Patar 

Hi,

 

Is it directly connected to the main Deco?

Please also provide the following information for us to check:

1. The network topology.

2. The screenshots of the speed test results and the retransmission rate result.

3. The specification of your Ethernet cable and the computer operation system.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
Re:TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection
Yesterday

  @Patar 

 

Hi, to assist you efficiently, I've forwarded your case to the TP-Link support engineers who will contact you with your registered email address later. Please pay attention to your email box for follow-up.

  0  
  0  
#3
Options