@David-TP Will this beta work for x50 with v1.30 hardware, or is there a separate beta? I am also having this issue

Hi David,

Yes I have a setup with x50-v1.3 (x3), and x20-v3 (x1) which is having the issues above. I have lots of Tapo IoT devices.

The x20-v2 are at a separate house and not having issues.

How do I add the other units to my ID?

I will submit the logs.

James

  @David-TP 

Thank you. I will give that a try.

Is it possible to make a version for the x50-v1.30 as well, as they are my main units?

I have two different networks under the same ID and can switch between them in the app, so I'm not sure why the other units aren't linked with my ID.

James 

  @David-TP 

Does this solve the other issue where the app shows the majority of devices in the "Offline Clients" list?

It seems to affect non TP-Link devices.

Edit: My X50-Outdoor upgraded via the IP address fine, but my three X55 V1 would not update via either method citing Update Failed.

I have a lot of tapo devices and have been having trouble with the deco app for a long time.

I've now used this update on my network consisting of 2 off x50 (1.2) and 4 off x20 (2.0), and can report all working perfectly so far.   The app shows all decos online along with the connected devices.  The web interface also shows the deco correctly.  

It has only been a few hours but I've not had the app work correctly in a long while.

I note the spash screen in the web interface shows for testing only, but seems stable. I look forward to the official update.

Thanks for this fix !

  @David-TP I have downgraded my M9 V1 Satellites and M9 V2 Main Deco to the suggested beta versions and the three satellites are now showing in the APP as connected and working perfectly. I had not managed to see this for a long time unless y disconnect most of my Tapo devices (only found out about root cause after reading this post), not many, 2 light bulbs, 5 smart plugs, 6 Cameras and 1 hub (and its dependent equipment). Everything seems to be working fine and connection between Decos is strong and looking good in the app. Was the fix just "cosmetic" for app display or does it improve connectivity too?

I do get however a message in the app now about "firmware upgrade available"

I was previously running 

M9Plus_en_1.6.4 Build 20240718 Rel. 76925_US_JP_EU_TW_CA_up.bin

and

M9Plus_1.0_en_1.6.4 Build 20240719 Rel. 40538_US_JP_EU_AU_up.bin

When will the fix in the beta versions I installed today be included in the latest versions so we can upgrade without loosing visibility of connectivity between decos?

Thanks

Guillermo A