How to use TL-WDR3600 router as a awitch
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to use TL-WDR3600 router as a awitch
Region : Others
Model : TL-WDR3600
Hardware Version : V1
Firmware Version : TL-WDR3600_V1_130320
ISP : Blizoo
Hello,
I just bought a TL-WDR3600 router and would like to use it in my existing network as a wired/wireless switch.
I have a D-link DIE-635 router with two wired devices; my desktop and a Toshiba e-studio 160 printer via an 8 port lan switch.
The switch has now failed as it is quite old, so I purchased the TL-WDR3600 to replace it in the network as a switch and increase my wireless range.
I have the TL-WDR3600 configured with no DHCP and Lan to Lan wired connection (Wan port empty). and the Toshiba wired to 1 of the 4 ports.
I can not connect to the printer like this and it also does not give me internet access through the wireless.
I have had the TL-WDR3600 configured as : Lan (Dlink) to Wan TL-WDR3600, DHCP enabled, Toshiba connected via wired , port 1.
This gives me internet access via the wireless on the TL-WDR3600 but still no connection to the printer and it is seen as multiple networks on my computer.
I also can't find any way on the TL-WDR3600 to see other devices connected to it (side note)
Can anybody help with advice as to hot to set the TL-WDR3600 as an access point so I only have 1 network (via Dlink) with the TL-WDR3600 as a wired.wireless switch?
Many thanks in advance,
Model : TL-WDR3600
Hardware Version : V1
Firmware Version : TL-WDR3600_V1_130320
ISP : Blizoo
Hello,
I just bought a TL-WDR3600 router and would like to use it in my existing network as a wired/wireless switch.
I have a D-link DIE-635 router with two wired devices; my desktop and a Toshiba e-studio 160 printer via an 8 port lan switch.
The switch has now failed as it is quite old, so I purchased the TL-WDR3600 to replace it in the network as a switch and increase my wireless range.
I have the TL-WDR3600 configured with no DHCP and Lan to Lan wired connection (Wan port empty). and the Toshiba wired to 1 of the 4 ports.
I can not connect to the printer like this and it also does not give me internet access through the wireless.
I have had the TL-WDR3600 configured as : Lan (Dlink) to Wan TL-WDR3600, DHCP enabled, Toshiba connected via wired , port 1.
This gives me internet access via the wireless on the TL-WDR3600 but still no connection to the printer and it is seen as multiple networks on my computer.
I also can't find any way on the TL-WDR3600 to see other devices connected to it (side note)
Can anybody help with advice as to hot to set the TL-WDR3600 as an access point so I only have 1 network (via Dlink) with the TL-WDR3600 as a wired.wireless switch?
Many thanks in advance,