ipv6 error
Hello. I do not know where to start I am an AX6000 user It has many problems and this is not my topic My topic is IPv6 Why does it not run on Note that I have another router from Huawei that supports IPv6 Why TP-Link, which I bought for close to $ 400, does not support I used all the tricks and could not run it
Please advise us of my greetings...
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi
Archer AX6000 supports ipv6:
https://www.tp-link.com/home-networking/wifi-router/archer-ax6000/#specifications
Below are some instructions to set up an IPv6 connection on the wireless router:
https://www.tp-link.com/support/faq/1525/
- Copy Link
- Report Inappropriate Content
@mr_goonf I had the same issue in my Archer AX53. In my case, I had to change the "Get IPv6 Address" type. So, if you are using "Dynamic IP" mode as well then try changing this to DHCP or SLAAC manually and see if that helps.
- Copy Link
- Report Inappropriate Content
All steps were done and did not work, knowing that I conducted an experiment on another router, but on the ax6000 I could not hope for the benefit
Recommended Solution
- Copy Link
- Report Inappropriate Content
All the tricks were tried and did not work, knowing that I conducted a test in another router from Huawei and it was run
Recommended Solution
- Copy Link
- Report Inappropriate Content
Hi
Can you please login to web management of AX6000 and then go to advanced > status to check IPV4 internet ip and check whether it is public ip or private one.
And is the IPv6 connection type the same as IPv4? Are both using Dynamic IPs?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi
It is recommended that you disable prefix delegation.
And select Get IPV6 Address as slaac.
Warm regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 385
Replies: 7
Voters 1