Home

Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > Setting up OneMesh with 2 routers (Archer A6 V2 & Archer C6 V4)

< Wi-Fi Routers

Setting up OneMesh with 2 routers (Archer A6 V2 & Archer C6 V4)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Setting up OneMesh with 2 routers (Archer A6 V2 & Archer C6 V4)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Chetas

2024-07-20 18:06:21 - last edited 2024-07-20 18:15:55

Posts: 8

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-01-29

Setting up OneMesh with 2 routers (Archer A6 V2 & Archer C6 V4)

2024-07-20 18:06:21 - last edited 2024-07-20 18:15:55

Hello TP Link Community,

I have 2 routers Archer A6 V2 which supports OneMesh and Archer C6 V4 which supports Easy Mesh & OneMesh but i'm not able to set both of them in a mesh setup. Currently Archer A6 is just shown as a client in Network map instead of Mesh Device.

Please help me with this.

Thanks & Regards

2 Reply

terziyski

LV7

2024-07-21 13:11:49 - last edited 2024-07-21 13:38:47

Posts: 7403

Helpful: 5618

Solutions: 1315

Stories: 7

Registered: 2013-10-12

Re:Setting up OneMesh with 2 routers (Archer A6 V2 & Archer C6 V4)

2024-07-21 13:11:49 - last edited 2024-07-21 13:38:47

@Chetas

There were successful attempts to build a mesh between an Easymesh and Onemesh routers.

To be able to do that A6 v2 (Onemesh) has to be your main router and C6 v4 (Easymesh) has to be the satellite device.

Use the WPS method to build a wireless backhaul mesh between those two - details.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

woozle

LV6

2024-07-21 13:35:57

Posts: 3223

Helpful: 2078

Solutions: 613

Stories: 0

Registered: 2020-05-01

Re:Setting up OneMesh with 2 routers (Archer A6 V2 & Archer C6 V4)

2024-07-21 13:35:57

Hi,

Just an additional note.

The screenshot above shows the Archer_A6 connected to the Archer C6 via "LAN".

Note that the WPS method mentioned does only work for creating a wireless Mesh between the Archer A6 V2 and Archer C6 V4. The LAN cable between the two routers must be disconnected, as otherwise it would cause problems.

Setting up OneMesh with 2 routers (Archer A6 V2 & Archer C6 V4)

Setting up OneMesh with 2 routers (Archer A6 V2 & Archer C6 V4)

Information

Voters 0

Tags