DECO X10 didn't get full speed when in Access Point mode.
Hai All,
I facing issue with Deco X10 where didn't get full speed on the Wi-Fi 6. My subscription is 200Mbps up and down. The reason why I use Deco X10 as AP mode is because I'm using pfsense as my main router while Deco X10 as AP only.
1. Doing testing using direct switch - able to get 200Mbps up and down.
2. Doing testing using LAN port at Deco X10 - able to get 200Mbps (Nearly 200Mbps) up and down.
3. Doing testing using Wi-Fi 6 - Able to get 137Mbps down and 146Mbps for up.
4. Set Deco X10 as router mode + PPPoE - Able to get 200Mbps up and down.
I've also try do as below :
1. Downgrade to the lowest version of Firmware - Cannot get 200Mbps up and down for Wifi.
2. Try to upgrade firmware follow the path - Cannot get 200Mbps up and down for Wifi.
3. Disable flow control - Cannot get 200Mbps up and down for Wifi.
4. Disable OFDMA + MU-MIMO + BEAMFORMING - Cannot get 200Mbps up and down for Wifi.
Apprecite if anyone could advise what should I do next. Please be informed that the Access Point mode doesn't have QoS, so it disabled by default.
Speedtest using LAN direct switch.
Speedtest using Wi-Fi6 from Deco X10
Direct LAN port at Deco X10
Using other router as AP (Wifi 5 only).
Wi-Fi 6 link speed is 1081Mbps for RX 961 for TX.