Home

Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > Put my Archer AXE5400 in Access Point but ?

< Wi-Fi Routers

Put my Archer AXE5400 in Access Point but ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Put my Archer AXE5400 in Access Point but ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Oops01

2024-07-09 21:44:13 - last edited 2024-07-10 10:06:24

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-07-09

Put my Archer AXE5400 in Access Point but ?

2024-07-09 21:44:13 - last edited 2024-07-10 10:06:24

Tags: #Access Point Mode

Model: Archer AXE5400

Hardware Version:

Firmware Version: 1.2.1 Build 20240607

Hi all, I was reading an article about putting your AXE5400 into the access point mode to use with the Quest 3 so I followed the instructions. Now I find I can't reach the router via my browser, so I have no way of returning it to its original setting/ taking it out of access mode.

Is there any way of reversing this if I want to go back to using the router as it was before I changed it?

1 Accepted Solution

terziyski

LV7

2024-07-10 00:01:11 - last edited 2024-07-10 10:06:24

Posts: 7209

Helpful: 5442

Solutions: 1255

Stories: 7

Registered: 2013-10-12

Re:Put my Archer AXE5400 in Access Point but ?-Solution

2024-07-10 00:01:11 - last edited 2024-07-10 10:06:24

@Oops01

Yes, there is. Fastest one is to reset the AXE5400 to its factory defaults by pressing the reset button for about 10 seconds.

The other one is to find its IP address on your main router and use http://router_IP_address to login the device and chaneg its operation mode.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Recommended Solution

2 Reply

terziyski

LV7

2024-07-10 00:01:11 - last edited 2024-07-10 10:06:24

Posts: 7209

Helpful: 5442

Solutions: 1255

Stories: 7

Registered: 2013-10-12

Re:Put my Archer AXE5400 in Access Point but ?-Solution

2024-07-10 00:01:11 - last edited 2024-07-10 10:06:24

@Oops01

Yes, there is. Fastest one is to reset the AXE5400 to its factory defaults by pressing the reset button for about 10 seconds.

The other one is to find its IP address on your main router and use http://router_IP_address to login the device and chaneg its operation mode.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Put my Archer AXE5400 in Access Point but ?

Put my Archer AXE5400 in Access Point but ?

Information

Voters 0

Tags