Official Release Deco X50/X55 V1 1.5.5 Optimize The Overall App Experience / Network stability
This Article applied to:
Deco X50/X55_V1/1.6_1.5.1/1.5.0
Firmware Download Link:
| Deco X50_V1/1.6 | 1.5.5_build_20240718 (Official Version) |
| Deco X55_V1/1.6 |
1.5.5_build_20240718 (Official Version) |
Update Advice:
1. Please make sure the Deco APP is up-to-date.
2. How to manually update the firmware via web UI- How to Update the Firmware of Deco.
Modifications and Improvement
1. Supported configuring IPv6 during setup.
2. Added the low-power feature.
3. Enhanced the VPN performance.
4. LED schedule feature supported control of individual device LEDs.
5. Improved the overall Deco App experience, especially with the online client list status.
6. Increased networking number.
7. Enhanced the system security.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
JanRekenaar wrote
@JPNARF do you have Deco x50 EU version 1.0? How is firmware 1.5.5 holding up?
@JanRekenaar from now, good... But with my AX201 card version 1.5.1 was better.
I found a couple of lags using Zoom or Teams.
- Copy Link
- Report Inappropriate Content
Hi, the official 1.5.5 has been updated.
(Deco X50/X55_V1 shared the same firmware download link)
Please feel free to update here about how the new 1.5.5 version works.
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
@David-TP The firmware download on the first page of this topic also points to the same X55 file. I can't seem to find the X50 1.5.5 anywhere on the site.
- Copy Link
- Report Inappropriate Content
Hi,
Why there's no X60 topic? Is the product end of life? Should I go with the X50 for future firmware updates?
- Copy Link
- Report Inappropriate Content
@David-TP Thanks David. Upgraded one x55 Mesh (three nodes) to 1.5.5 last night. So far so good.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@David-TP "If the official 1.5.0 build 0417 works well on your Deco, I think you could wait for the official version later."
That version is not available on the EU version of X55. The latest available is still 1.4.1. Is this for US only?
- Copy Link
- Report Inappropriate Content
Hi David, may I know what is low power feature and how do I get to the options for it. can't seem to find this setting from the deco app.
- Copy Link
- Report Inappropriate Content
Hi, from the comments left by the engineers, It is to reduce the working power for smart IoT devices, such as security cameras.
I don't have any more details yet but will update again after checking with the engineers.
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
Hi, It is for both EU and US versions.
Deco X50 could use the same firmware file as Deco X55. The software is the same and during the upgrade process, it will automatically abstract the correct units based on the embedded region code of the hardware.
I didn't receive a separate link for Deco X50 yesterday but now the web support helps me get a separate link for Deco X50. You could use the new download link.
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 16689
Replies: 144
Voters 0
No one has voted for it yet.