Using RE605X as an AP in a Mesh Network Setup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Using RE605X as an AP in a Mesh Network Setup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EduardoRissao

2024-05-13 14:42:22

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-05-13

Using RE605X as an AP in a Mesh Network Setup

2024-05-13 14:42:22

Model: RE605X

Hardware Version: V2

Firmware Version: 1.0.3 20230907 Rel. 38400

Hello!

I have a TP-Link EX220 router as the main one in my house, and now I bought a RE605X repeater to extend the network signal.

However, at the point where I will place the repeater, I have a cable ready (which connects directly to the main router).

Can I use the RE605X as an AP, using a mesh network (instead of creating two separate networks)?

When setting it up, it worked perfectly as an Access Point, but it created another separate network and I didn't find this setting when it was as an AP (only if it was as a repeater).

1 Reply

terziyski

LV7

2024-05-13 19:24:31

Posts: 7017

Helpful: 5225

Solutions: 1159

Stories: 7

Registered: 2013-10-12

Re:Using RE605X as an AP in a Mesh Network Setup

2024-05-13 19:24:31

@EduardoRissao

RE605X do not support mesh in AP mode nor Easymesh ethernet backhaul.

You should use RE605X in RE mode and connect it wirelessly to your router to build a mesh.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".

Using RE605X as an AP in a Mesh Network Setup

Using RE605X as an AP in a Mesh Network Setup

Information

Voters 0

Tags