TP Link 10-port Switch - What ports do I use?
Many apologies if this comes across as a noob question but I am unable to find a succinct answer on the internet.
I have recently purchased a TP Link LS1210GP 10-port switch, together with a TP Link Deco X50-POE 3-pack so that I can install a mesh network in my bungalow.
I've successfully commissioned the Deco kit (using their individual power adapters) and am now looking to incorporate the LS1210GP into the mix so that I can take advantage of the POE features that it provides.
What I would like to know is what port on the switch would the primary node connect into? Any of the ports 1 through 8, or Uplink 1?
I think that I am safe that I can use either of the two 2 gig ports on the primary node to connect to the switch.
Any thoughts/comments/advice much appreciated.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
On this switch Ports 1–8 supports PoE+ output. So if you're about to use Deco PoE+ feature you can use any of the 1-8 port.
- Copy Link
- Report Inappropriate Content
@terziyski Thanks for your quick response.
What would be the connectivity trail?
Would it be:
Internet - ONT - Deco X50 POE - TP Link Switch - Device or
Internet - ONT - TP Link Switch - Deco X50 POE - Device?
Would the connectivity change depending on whether or not I used POE or supplied adapter?
Best regards
Banjo
- Copy Link
- Report Inappropriate Content
Deco ports are auto-sense so it shouldn't matter to which port of the main Deco unit you've connected the switch.
This document could shed some light on the topology that you should use - first two scenarios are for Deco in router mode.
Last scenario is for Deco in AP mode - this is usually used if you have already a router to avoid the double NAT.
Network topology shouldn't change whether you're using the supplied adapters or the PoE.
- Copy Link
- Report Inappropriate Content
terziyski wrote
Deco ports are auto-sense so it shouldn't matter to which port of the main Deco unit you've connected the switch.
This document could shed some light on the topology that you should use - first two scenarios are for Deco in router mode.
Last scenario is for Deco in AP mode - this is usually used if you have already a router to avoid the double NAT.
Network topology shouldn't change whether you're using the supplied adapters or the PoE.
@terziyski Thanks very much again for the speedy response and the helpful information contained therein. Hopefully I will be able to commission my new TP POE switch this weekend and install the ethernet backhaul.
- Copy Link
- Report Inappropriate Content
Thank you both. I was having the same problem and didn't know how to solve it until I read this article.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 866
Replies: 5
Voters 0
No one has voted for it yet.