Powerline funktioniert nicht

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Powerline funktioniert nicht

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Powerline funktioniert nicht
Powerline funktioniert nicht
2024-04-14 17:41:06 - last edited 2024-04-16 02:00:56
Model: Deco X50-5G   Deco PX50  
Hardware Version: V2
Firmware Version: New

Hallo, ich habe ein Problem mit meinem deco Netzwerk . mein x50-g5 arbeitet als Router. Ich habe 3 Px50 als Clients angeschlossen . allerdings bekomme ich die nicht in den powerline- Modus . kann mir jemand helfen ? Danke 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Powerline funktioniert nicht -Solution
2024-04-15 03:30:15 - last edited 2024-04-16 02:00:56

  @CalaPi 

Hi, welcome to the community.

It is suggested to refer to Q2 on General Questions about the Powerline or PLC Backhaul Feature of Deco

Q2: How to enable the Powerline Backhaul feature?

Powerline Backhaul doesn't need to be turned on by any hardware or software switch, and it takes effect automatically as long as:

  1. When Deco PX50/P7/P9 is used as the Main Deco.
  2. Two or more Deco PX50 under the same power grid, or two or more Deco P7/P9 under the same power grid.

The Powerline Backhaul works between two Deco PX50 or two Deco P7/P9.

 

I think you might need to connect the first PX50 via an Ethernet cable to Deco X50-5G, then create a new Mesh network via these 3*Deco PX50 on the Deco APP.

How to Create a New Network in the Deco App

Thank you very much and best regards.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Powerline funktioniert nicht -Solution
2024-04-15 03:30:15 - last edited 2024-04-16 02:00:56

  @CalaPi 

Hi, welcome to the community.

It is suggested to refer to Q2 on General Questions about the Powerline or PLC Backhaul Feature of Deco

Q2: How to enable the Powerline Backhaul feature?

Powerline Backhaul doesn't need to be turned on by any hardware or software switch, and it takes effect automatically as long as:

  1. When Deco PX50/P7/P9 is used as the Main Deco.
  2. Two or more Deco PX50 under the same power grid, or two or more Deco P7/P9 under the same power grid.

The Powerline Backhaul works between two Deco PX50 or two Deco P7/P9.

 

I think you might need to connect the first PX50 via an Ethernet cable to Deco X50-5G, then create a new Mesh network via these 3*Deco PX50 on the Deco APP.

How to Create a New Network in the Deco App

Thank you very much and best regards.

Recommended Solution
  0  
  0  
#2
Options