MLO network broken for s 24u after update
My router just updated today to the latest firmware version and it broke the mlo network for my S24 Ultra. Where is constantly dropping connection from it. I try rebooting, factory resetting and even a firmware downgrade, but I get an error.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
The latest update which is 1.1.6 Build 20240808 rel.26673 has fixed my issues. I recommend updating.
- Copy Link
- Report Inappropriate Content
The error you're getting is most probably because you're not allowed to downgrade to a previous FW release from the curren one.
- Copy Link
- Report Inappropriate Content
@terziyski Ah, that's too bad, because the version before this one is more stable.
- Copy Link
- Report Inappropriate Content
That's just a suggestion because your FW version is not listed yet on the BE800 support portal. Which FW region your router is - you can check that on its bottom sticker.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If you open the BE800 US support portlal - https://www.tp-link.com/us/support/download/archer-be800/v1/#Firmware
You won't see this FW release because it's a brand new - I assume you received it through a FW auto-update feature recently.
I assume that you own HW v1 - that's on the bottom sticker as well.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
When looking for your HW version the following rule applies:
Normally Vx.0=Vx.6/Vx.8 (eg:V1.0=V1.6/V1.8); Vx.x0=Vx.x6/Vx.x8 (eg:V1.20=V1.26/V1.28
So it's quite normal that these are the same FW releases as for HW v1.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Yes, you did it right - bottom sticker has precedence over other info (like the WebGUI). In your case though, it wouldn't matter.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2929
Replies: 27
Voters 0
No one has voted for it yet.