Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Problems setting up Deco M5 with BT full fibre hub

< Deco

Problems setting up Deco M5 with BT full fibre hub

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Problems setting up Deco M5 with BT full fibre hub

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Martlet86

2024-03-29 01:15:35

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-03-29

Problems setting up Deco M5 with BT full fibre hub

2024-03-29 01:15:35

I Had an EE router working with my 3 station M5 mesh network. Today I went to BT full fibre now my master M5 unit flashes blue but will not go to steady blue. The Ethernet cable is plugged into one of the hub's yellow Ethernet ports. Is there an incompatibility between DecoM5 and BT full fibre. I have tried everything x power off/on, reset button different ports on the hub and the M5 but the blue light refuses to go to solid blue

any ideas anyone?

2 Reply

David-TP

2024-03-29 08:05:18

Posts: 12443

Helpful: 1716

Solutions: 1197

Stories: 9

Registered: 2020-04-14

Re:Problems setting up Deco M5 with BT full fibre hub

2024-03-29 08:05:18

@Martlet86

Hi, Did you reset Deco M5 before or remove it from the Deco APP since flashing blue means Deco has been reset into setup-ready mode?

Maybe you could go back to Deco APP>"+" on the top right>create a network to set up M5 again.

Wait for your reply and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! Deco BE85_1.1.1 Supports WireGuard VPN,Channel Selection and Matter Deco BE65_V2_1.1.0 Supports WireGuard VPN, Channel Selection and More ▶Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.

klipse

LV3

2024-03-29 10:23:23

Posts: 174

Helpful: 97

Solutions: 13

Stories: 0

Registered: 2019-07-08

Re:Problems setting up Deco M5 with BT full fibre hub

2024-03-29 10:23:23

@Martlet86

Try removing the BT hub altogether and connect the master M5 direct to the BT FTTP ONT via ethernet cable, then configure a PPPoE connection, username and password can be taken from BT hub or are on the web via google search.

BT Full fibre 500, 1x X60 V3.2 in router mode and 1 x XE75Pro V2.

Problems setting up Deco M5 with BT full fibre hub

Problems setting up Deco M5 with BT full fibre hub

Information

Voters 0

Tags