DUAL WAN on MAIN AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

DUAL WAN on MAIN AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
DUAL WAN on MAIN AP
DUAL WAN on MAIN AP
2024-03-23 10:03:30 - last edited 2024-03-23 10:08:44
Model: Deco M4  
Hardware Version: V3
Firmware Version: V3_1.6.1 Build 20231228

Based on my attempt to connect two ISPs directly to the MAIN AP model Deco M4 resulted in a normal failover behavior rather than a load balancing feature. The issue highlighted is the inability to select a primary ISP manually. Even after removing ISP1 and allowing ISP2 to take over, reconnecting ISP1 still assigns the IP address associated with ISP2, indicating a limitation in the load-balancing functionality of the setup.

  0      
  0      
#1
Options
1 Reply
Re:DUAL WAN on MAIN AP
2024-03-25 08:57:11

  @Nukos 

Hi, Welcome to the community.

Maybe you could refer to the following post to add a router that supports Link failover. Deco doesn't support setting a primary connection and it will always recognize the WAN connection that first assigned the IP address, as the primary one.

How to use Deco with two ISPs?

Best regards.

  0  
  0  
#2
Options