Deco M4 V2 Cannot access webui 1.1.9 Build 20200119 Rel. 75362
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I just unboxed 3 Deco M4 and tried to view the Web UI but I cannot access it using 192.168.68.1, tplinkdeco.net and tplinkwifi.net. Firmware Version 1.1.9 Build 20200119 Rel. 75362. I need help on how to access it so I can update the firmware.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, is the Deco provided by your internet service provider?
1.1.9 Build 20200119 Rel. 75362 is a local-customized version for PLDT/PH and this version doesn't support web UI.
It is suggested to contact the ISP directly to request a firmware upgrade.
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
**Update: Yes, it is provided by PLDT, and I already fixed it.**
This is how I did it:
First, download the latest version of firmware depending on the version of Deco M4 you have (Note: V3 Firmware will not work on V2, and vice versa).
You can find the Deco M4 version on the bottom sticker.
Connect a cable from your Deco to your Laptop/PC and change the IP Address to static 192.168.0.2.
Next, long-press the reset button while plugging the power plug into the Deco. The Deco will light up yellow. While still pressing the reset button, wait for the light to turn off.
At this point, go to your browser and type 192.168.0.1, then upload the latest firmware that you downloaded from the Deco firmware page.
After successfully uploading the latest firmware, unplug the power from the Deco and plug it back in.
Now, you can check from your browser by going to 192.168.68.1 or 192.168.68.1:30000, and the Web UI will be accessible.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 406
Replies: 3
Voters 0
No one has voted for it yet.