DECO S4 V2.0 and V4.0

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

DECO S4 V2.0 and V4.0

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

HriD

2024-03-13 06:32:30

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-03-13

DECO S4 V2.0 and V4.0

2024-03-13 06:32:30

Tags: #Network Connectivity

Model: Deco S4

Hardware Version: V2

Firmware Version:

Hello. I have 3 unit deco S4 - V2.0 and another 3 units S4 - V4.0 in my house connected in a mesh system.

Very often after opening the DECO APP it show most of the units are offline, but they actually are online. When I refresh the app the units go online again.

All of the units are upgrade to the latest software version - The V2.0 is upgraded to software version - 1.6.1 Build 20231228 Rel. 59072 and the V4.0 are 1.1.2 Build 20231227 Rel. 84005

Also my Decos V4.0 have the Connection preference but it does not allow me to save the desired signal source.

The V4.0 units are connected to the mesh system after the main mesh router which is V2.0

Should I change the main router with hardware version V4.0 unit in order to allow me to chose desired source signal?

1 Reply

Omochao

LV2

2024-03-13 07:12:39

Posts: 70

Helpful: 37

Solutions: 2

Stories: 0

Registered: 2024-02-05

Re:DECO S4 V2.0 and V4.0

2024-03-13 07:12:39

@HriD

Yes, always place the latest version as the main node if possible, unless there is something that there isnt working, then more often than not, should you use a lower tier one as the main.

But again, for all the features to be available, the supported features must be on the same firmware as all others.

So for your question of signal connection preference, it might work once you replace that V4 as your main, if not, just wait for the S4 V2 to update to the latest firmware for the new features.

DECO S4 V2.0 and V4.0

DECO S4 V2.0 and V4.0

Information

Voters 0

Tags