Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Deco Configuration

< Deco

Deco Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco Configuration

Vraze

2024-03-01 15:49:16 - last edited 2024-03-04 11:31:16

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-03-01

Deco Configuration

2024-03-01 15:49:16 - last edited 2024-03-04 11:31:16

Tags: #Network Connectivity #Installation

Model: Deco M5 Deco M4

Hardware Version: V3

Firmware Version: 1.3.14

Which of these 2 scenario works for deco system?

Do all other additional deco need to be in range of the main deco or can it connect to other additional deco unit like shown on diagram below?

note: all this is connected through wireless. the only cable attached are into the main deco

i am using deco m5 v3 US firmware 1.3.14
and deco m4R v2 US firmware 1.6.1

Thanks

1 Accepted Solution

Alexandre.

LV6

2024-03-01 16:29:35 - last edited 2024-03-04 11:31:16

Posts: 4002

Helpful: 2328

Solutions: 524

Stories: 0

Registered: 2020-10-22

Re:Deco Configuration-Solution

2024-03-01 16:29:35 - last edited 2024-03-04 11:31:16

@Vraze

See Connection Preference: Customize Your Preferred Signal Source

Recommended Solution

3 Reply

Vraze

LV1

2024-03-01 15:49:54 - last edited 2024-03-01 15:51:30

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-03-01

Re:Deco Configuration

2024-03-01 15:49:54 - last edited 2024-03-01 15:51:30

this is the 2nd scenario @Vraze

Wrayman

LV2

2024-03-01 16:08:39

Posts: 97

Helpful: 50

Solutions: 3

Stories: 0

Registered: 2023-02-06

Re:Deco Configuration

2024-03-01 16:08:39

@Vraze the Deco network doesn't need every single unit to connect to the main unit. Ideally they should all be spread out evenly to cover the various corners of your property. The farthest unit might not even be able to pick up a fringe signal from your main unit but as long as there is an unbroken chain back to the main node they should all work.

XE75 V1.0 3-pack / Wired backhaul / Router mode / UK

Alexandre.

LV6

2024-03-01 16:29:35 - last edited 2024-03-04 11:31:16

Posts: 4002

Helpful: 2328

Solutions: 524

Stories: 0

Registered: 2020-10-22

Re:Deco Configuration-Solution

2024-03-01 16:29:35 - last edited 2024-03-04 11:31:16

@Vraze

See Connection Preference: Customize Your Preferred Signal Source

Deco Configuration

Deco Configuration

Information

Voters 0

Tags