I bought a pack of 2 x Deco S7 sattelite nodes today to add to my existing 3 x Deco S7 mesh system. Both new nodes were added without problems and were. Prompted to update both from firmware v1.4.1 to v1.4.5.after setup. One updated succesfully, but the other one seems to be stuck in a loop, prompting to download the latest firmware , and indicating that it was succesfully installed, untill you go back into the main setup screen where it shows its still v1.4.1, and prompts you to update it again. Did it 5 times already without any success. Ive also reset the deco unit as well, but no luck in updating from v1.4.1 to v1.4.5. Anyone else have this issue?