Home Network Community > Deco > Reached maximum number of users
< Deco

Reached maximum number of users

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Reached maximum number of users

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Reached maximum number of users
Reached maximum number of users
2024-02-07 17:14:36
Tags: #Access Point Mode #IoT Network
Model: Deco M4  
Hardware Version:
Firmware Version: 1.5.2 Build 20210916

Hi Everyone,

 

ı'm using my deco m4 devices as an accesspoint, I have a lot of IoT devices and computer in my home. When i try to connect to my wifi, i see this message "reached maximum number of users"  Is there any limitation for connection number? If i disconnect a device, i can connect new device to the my wifi but otherwise it's not possible. What can be issue? 

  0      
 
  0      
 
#1
Options
7 Reply
Re:Reached maximum number of users
2024-02-08 00:03:29
Out of curiosity, how many total devices has been connected to your M4 at the moment?
  1  
  1  
#2
Options
Re:Reached maximum number of users
2024-02-08 19:10:38

  @Omochao I'm using 3 x Deco m4, totally 30 device

  0  
  0  
#3
Options
Re:Reached maximum number of users
2024-02-10 08:37:16
Perhaps that is the maximum it can connect to reach contrary to the website details about it reaching up to 100 devices. Consider upgrading the device then
  0  
  0  
#4
Options
Re:Reached maximum number of users
2024-02-10 14:35:35

  @GroupPolicy Where do you see the "max users" message?

If the Deco works in AP mode, another device is acting as DHCP server.  This device is perhaps not configured to handle more than 30 active users.  The DHCP range is perhaps too small.

  2  
  2  
#5
Options
Re:Reached maximum number of users
2024-02-11 19:00:01

  @yves_b  When i connect a device to the network,İt's opening on web browser automatically and seen there. I'm using dhcp server on synology nas and there is no any space issue.

  0  
  0  
#6
Options
Re:Reached maximum number of users
2024-02-11 19:20:48

  @GroupPolicy Where does the web page come from?

How many IP addresses to be distributed did you configure on your DHCP server?

  0  
  0  
#7
Options
Re:Reached maximum number of users
2024-02-11 19:30:01
Between 192.168.1.10 - 192.168.1.250
  0  
  0  
#8
Options

Information

Helpful: 0

Views: 1276

Replies: 7

Tags

Access Point Mode IoT Network
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.