TPLink Extender Not Working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TPLink Extender Not Working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TPLink Extender Not Working
TPLink Extender Not Working
2024-01-23 20:29:14

My model is RE200

 

it was working fine then it decided not to connect at all. I hard reset it and put it against the router and it's still not working. Any tips?

  0      
  0      
#1
Options
1 Reply
Re:TPLink Extender Not Working
2024-01-24 06:24:45

  @Hamy16 

 

Hi, for your case, here are some suggestions. 
1. Please check whether Wireless password of your new router you entered is correct or not? Please go to Settings--WiFi on your phone to forget the new router WiFi, then reconnect it using the same Wi-Fi password to see if it works. 
2. Please reset the extender into default settings again by holding the reset button until all lights flashing once, then refer to this instruction to configure your range extender again carefully:

Via Tether App: https://www.tp-link.com/support/faq/1373/
Via Web interface: https://www.tp-link.com/support/faq/1400/

 

Note: During the configuration, please make sure that the extender is close to your router and be careful when you enter router's wireless password.  

 

If it still doesn't connect, please check if there is any special settings on your main router, like access control etc. which will block the extender.

If no such special settings, please let us know the following information:

1) hardware version and the LED status of your range extender
2) distance between range extender and your router
3) model number and hardware version of your main router

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options