Beta Software Deco M4/S4_V2 Support Connection Preference
This Article applied to
Deco M4_V2_1.5.8
Deco S4_V2_1.5.1
Download Link:
| Deco M4_V2 | Deco M4_V2_1.7.0 ( New version updated on 2024.3.7) |
| Deco S4_V2 | Deco S4_V2_1.6.1_build_20240328 (updated on 2024.4.19) |
1. Please be sure you have read the Terms and Conditions for TP-Link Beta Firmware before proceeding.
2. For Deco M4_V2, the firmware downgrade(back to the official 1.5.8 version) needs to be implemented via firmware recovery.
3. For Deco S4_V2, it would revert to the official 1.5.1 directly via web UI.
4. How to update the firmware via web UI.
Firmware Modifications:
| Deco M4_V2_1.7.0 |
|
| Deco S4_V2_1.5.1 |
|
Please feel free to comment below if you have any issues with these two firmware versions!
Related Articles:
Connection Preference: Customize Your Preferred Signal Source
Understand the Differences Among Deco Firmware Platforms
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Lalolelendo ah....! Beta version
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, I'm afraid the 1.7.0 beta is for Deco M4_V2 only. Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP thank you for your response. In my house i have a mesh network from two V2's and two V3's M4R Deco. If i install the beta firmware to the V2's , the connection preference will be available to all of my Deco units?
- Copy Link
- Report Inappropriate Content
Is there any eta on when tis feature will be added to the normal firmware and no longer be in beta?
Because if this is added to the normal update stream then i can be sure that it qill not cause any issues with bugging out and can safely buy another m4 to finally replace the last deco in my mesh that doesn't support this feature
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Time to face the music, TP-Link have moved on from this model. It's over. Time to buy something else. Won't go near TP-Link again. Been poor performance since day one.
- Copy Link
- Report Inappropriate Content
@David-TP Why Connection Preference does'nt work sometime? When i force devices to keep connect on specific deco or specific band why my devices keep connected on unselected Deco's ? I have forced my phone to connect on 5 GHz band but my phone is connected on 2.4 GHz band...Why?
- Copy Link
- Report Inappropriate Content
First post here after I've browsed quickly through all this thread. I've got a mesh consisting of a bunch of M4 V4's running the latest stable version, which I think should support client connection preference. I also have a M4 V2 in the network, running 1.6.2.. The connection preference option does not appear on any Deco and I assume that's because of that V2, so (again) I assume I'll have to upgrade it to 1.7.0.
But the web UI upgrade method does not seem to be able to select a specific Deco for upgrade. Trying to run 1.7.0 upgrade obviously failed. May I please ask if I have to turn off all V4's first and isolate the V2 only so that I can hopefully upgrade it to 1.7.0 via web UI?
Thanks!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 6
Views: 44270
Replies: 246
Voters 3
