Official Release Optimize The Overall App Experience on Deco XE5300/XE75/XE75 Pro
This Article applied to:
Deco XE5300/XE75/XE75 Pro_V2
Firmware Download Link:
Deco XE5300/XE75_V2 | 1.2.8_Build 20240328 (6.21 updated) |
Deco XE75 Pro_V2 | 1.2.10_build20240325 (6.21 updated) |
Update Advice:
1. It would be more effective for a mesh network with more than three Deco XE3500/XE75/XE75 Pro_V2, and over 40 connected clients.
2. How to update the firmware via web UI.
Modifications and Improvement:
1. Improved the overall Deco App experience, especially with the following reported phenomenon:
- Satellite Deco units are solid green while Deco APP reported offline.
- Certain connected clients don't show up on the Online Client List or the displayed count of connected clients is inaccurate.
- When opening the Deco App, it takes quite a while to respond or update the network status.
2. Optimized web upgrade efficiency.
Please feel free to comment below how much this firmware has improved your network.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@tonyjp2022 glad to hear that the new firmware is working well. Unfortunately I'm in the UK so it looks like I'll have to wait for now.
tonyjp2022 wrote
Deco XE75 Pro_V2 1.2.10_build20240325 (6.21 updated the clients are displaying the sppeds showing traffic on both deco
- Copy Link
- Report Inappropriate Content
I've been running the 1.2.10_build20240325 (6.21 updated) for a week now.
It is certainly more responsive with the app refreshing clients and showing transfer speeds more quickly and reliably.
However, the wifi network now seems to reboot a few times a day. I lose connection and see all satellites blinking red, and when I go to the main unit (XE75 Pro V2), it is solid yellow, so it appears to be rebooting.
A couple of minutes later, everything goes green, but these frequent unscheduled disruptions are frustrating and unacceptable with internet and streaming dropping out.
I was not getting this prior to the upgrade to 1.2.10. I hope a further update in the near future can address this issue.
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
Thank you very much for your feedback.
Is there any chance that you could save the system log on the web UI and send it to support.forum@tp-link.com?
How to log into the web-based interface of my Deco
Apart from the firmware upgrade, have there been any other changes recently?
By the way, how many times you have seen Deco restart itself so far?
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Thanks @David-TP.
I experienced the Wi-Fi dropout and the main XE75Pro(2.0) reboot on at least 6 separate occasions whilst I was streaming or gaming this weekend. (It may have occurred at other times that I didn't notice when I wasn't online as the system comes back without any intervention from me in around 5 minutes).
The only additional recent change to my setup was adding a Surfshark VPN to the router with selected clients (mainly cameras and IoT devices), but I removed this last Friday, and subsequently kicked my FTTP connection and power-cycled the XE75Pro and the problem continued to occur. (I have also disabled Fast Roaming, Beamforming and QoS to remove them as potential causes).
As requested, I have sent logs captured after a couple of the reboots, and more detailed configuration information to support.forum@tp-link.com.
I hope this allows them to detect a configuration issue that either they, or I, can address.
I'll report back with their findings.
- Copy Link
- Report Inappropriate Content
Hi, Thank you very much for the update.
I haven't find any email from you(via the community registration email address). Did you send the logs via another email?
I also left my own email in the Message . Could you please send the email again and add my email on the cc list?
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Thanks @David-TP.
Just noticed the original email stuck in my outbox.
Sending it through now, together with another log from a Wi-Fi dropout just minutes ago.
Cheers,
Patrick
- Copy Link
- Report Inappropriate Content
Thank you very much for the update.
The email has been received and forwarded to the senior engineer for further assistance.
Please check the email later for more suggestions.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi @David-TP,
I am experiencing the same issues described by OzPatricio. My network consists of seven Deco units: three XE75 Pro (2.0) running firmware 1.2.10 Build 20240325 Rel. 57182, and four M5 (3.0) running firmware 1.7.4 Build 20231222 Rel. 63684. One of the XE75 Pro units is the main one.
I will send the system logs to TP support via email, as there are numerous error messages.
My network experiences frequent outages several times a day. I receive push notifications from my IoT devices, and I observe the Wi-Fi signal on my notebook fluctuating from strong to weak during these drops.
Additionally, is there any planned upgrade for the M5 devices? The latest one is from December 2023.
Thank you,
Alexandre Wada
- Copy Link
- Report Inappropriate Content
Information
Helpful: 6
Views: 11035
Replies: 68