Deco m5 and load balancer
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have 2 Isp . I have a load balancer tplink 470t+ . I have connected both isp input from the router to the 2 wan ports on the load balancer. I need to ensure that load balancing works and failover mechanism works. So i have connected a lan cable from the loadbalancer to deco. The deco is set in AP mode.It keeps showing no signal. How do I ensure this works that is when first isp fails the second network is projected by deco with the help of load balancer.
Hi, Thanks for the feedback.
Your network topology is perfect and should work as expected.
I wonder If the main WAN 1 doesn't connect yet, How about the backup wan 2? is it also not connected yet?
Have you checked the WAN Status list under Transmission->Load Balancing->Online Detection?
If the main ISP hasn't been connected but backup WAN 2 does, the WAN 1 Status should be offline and the backup-WAN 2 should be online.
Thank you very much and best regards.
Hi, Thanks for the feedback.
Your network topology is perfect and should work as expected.
I wonder If the main WAN 1 doesn't connect yet, How about the backup wan 2? is it also not connected yet?
Have you checked the WAN Status list under Transmission->Load Balancing->Online Detection?
If the main ISP hasn't been connected but backup WAN 2 does, the WAN 1 Status should be offline and the backup-WAN 2 should be online.
Thank you very much and best regards.