Home Network Community > Wi-Fi Routers > How to configure OpenDNS FamilyShield on Archer C64 router
< Wi-Fi Routers

How to configure OpenDNS FamilyShield on Archer C64 router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to configure OpenDNS FamilyShield on Archer C64 router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to configure OpenDNS FamilyShield on Archer C64 router
How to configure OpenDNS FamilyShield on Archer C64 router
2023-12-01 15:39:22
Model: Archer C64  
Hardware Version: V1
Firmware Version: 1.13.2 Build 230824 Rel.74702n(5553)

I want to configure OpenDNS Family Shield IP DNS addresses in my router, basically 208.67.222.123 & 208.67.220.123. But I'm unable to find a way to do it. I tried a few settings but after making those changes, I wasn't able to connect to the internet and so had to revert back. Any help is appreciated. Thanks

  0      
 
  0      
 
#1
Options
3 Reply
Re:How to configure OpenDNS FamilyShield on Archer C64 router
2023-12-02 06:08:56

  @AshK47 

 

Try entering these DNSs here:

 

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options
Re:How to configure OpenDNS FamilyShield on Archer C64 router
2023-12-02 07:08:43

  @terziyski 

 

I already tried this, but it didn't work. After doing this change, I couldn't connect to the internet. Also, my internet connection type is PPoE.

terziyski wrote

  @AshK47 

 

Try entering these DNSs here:

 

terziyski wrote

  @AshK47 

 

Try entering these DNSs here:

 

 

  0  
  0  
#3
Options
Re:How to configure OpenDNS FamilyShield on Archer C64 router
2023-12-03 16:41:21 - last edited 2023-12-03 16:43:52

  @AshK47 

 

That's the only way to set a different DNS than these provided by your ISP, no matter what's the internet connection type (Dynamic IP or PPPoE).

That's covered on OpenDNS page as well - here, but I don't know why this doesn't work for you.

Double checking the DNS IP addresses on the OpenDNS guide I pointed the IP addresses are 208.67.220.220 and 208.67.222.222 - probably you should try these as well.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 1252

Replies: 3

Related Articles
Route configuration Archer C6
2621 0
 How to configure the TP-Link Archer VR900 v1 router to work with OpenDNS
1110 0
 Archer C6 configuration page issue
854 0
 Archer C6 VLAN ID Unable to Configure
925 0
 Archer C6 Firmware v1.3.4 failed to back up device configuration
1151 0
Setting up tp link Archer VR1600v for OpenDNS
89 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.