EasyMesh Set-up with one VX230v (as the main modem router) and another VX230v (as the agent)
Hi,
I am currently using a VX230v as the modem router. It works fine, it is connected to internet. Its EasyMesh is enabled. I want to use this as the EasyMesh Controller (as described in the device's Mesh menu).
I have also another VX230v. This one is in reset status (not logged in before trying to join the EasyMesh network / has not been configured). I want to use this as the EasyMesh Agent (also as described in the device's Mesh menu).
When I try to add a mesh device through the first VX230v Mesh menu (by pressing "Add Mesh Device" button), it prompts for next steps (pressing the WPS button on the second VX230v, ...) and I follow all of them. And then, both devices' WPS lights start blinking. However, at the end of the process, the device (agent) couldn't be added. Error in the first VX230v is: "Error! Failed to add the device!".
I also try the process via the Aginet, the result is same: "No devices found"
I also try the process as changing the each modem's role (reset the first one and try it as the EasyMesh Agent; reset and re-configurate the second one and try it as the modem router / EasyMesh Controller). The results are same.
Is there any way to set-up EasyMesh network with two VX230v devices?
Thanks.
Device: VX230v(EU1) AX1800 Dual Band Wi-Fi 6 VDSL/ADSL Modem Router
Firmware version: 0.11.0 2.0.0 v606c.0 Build 230105 Rel.7529n
Hardware version: VX230v v1.0 00000000
Explanation in VX230v's Mesh menu for EasyMesh Controller set-up:
Explanation in VX230v's Mesh menu for EasyMesh Agent set-up:
Error message:
