TL-WA1201 v3 Unable to configure client mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I reset this unit, completed the initial AP mode setup, then via a web browser (coudn't do this with the app) I changed it to client mode. The unit reboots and never connects to a wireless network and I am unable to reconnect to the previous IP.
Saving at this point will cause the unit to reboot. No instructions other than go to tplinkap.net, which only gives me pointers about using as an access point or range extender
Going to the IP by LAN never ever loads the interface:
Also, when I set up the AP mode, if I want ot get to the web UI, I have to bind the unit to my tether account otherwise it continuously logs me out when using the local password. Awful user experience.
meekamunz wrote
I reset this unit, completed the initial AP mode setup, then via a web browser (coudn't do this with the app) I changed it to client mode. The unit reboots and never connects to a wireless network and I am unable to reconnect to the previous IP.
Saving at this point will cause the unit to reboot. No instructions other than go to tplinkap.net, which only gives me pointers about using as an access point or range extender
Going to the IP by LAN never ever loads the interface:
Also, when I set up the AP mode, if I want ot get to the web UI, I have to bind the unit to my tether account otherwise it continuously logs me out when using the local password. Awful user experience.