DHCP configuration
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can you explain why i cannot change the DHCP address range from 192.168.0.xx to another range, e.g. 192.168.10.x. Surely this should be allowed ! or even a 10.x.x.x range ?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
As @SergejKiller posted, you should first set the router LAN IP address within the desired subnet and then set the DHCP IP address pool.
That is because router LAN IP address should correspond (be within the same subnet) as the DHCP Server IP address pool.
- Copy Link
- Report Inappropriate Content
@RichStaf, You have to do this from LAN settings page, not from DHCP.
- Copy Link
- Report Inappropriate Content
As @SergejKiller posted, you should first set the router LAN IP address within the desired subnet and then set the DHCP IP address pool.
That is because router LAN IP address should correspond (be within the same subnet) as the DHCP Server IP address pool.
- Copy Link
- Report Inappropriate Content
I also have a problem with DHCP server. I do not understand the limitation that "Address Reservation" IPs should be inside the DHCP allocation pool.
In other words I have DHCP range from 192.168.0.100 - 192.168.0.200 and I cannot add address reservatoin with IP 192.168.0.10. This restriction is annoying and totally unnessesary.
- Copy Link
- Report Inappropriate Content
I believe the logic behind this is that address reservation make sense only when devices receive their IP address by DHCP.
Outside DHCP Server IP address pool you can set a static IP addresses for client devices.
There's also IP&MAC binding ARP anti-spoofing mechanism to bind an IP address to a particular MAC address that you can use for these.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If I understood correctly you need a different DNS server on the LAN side of the TP-Link router. If that's correct you can do that here:
- Copy Link
- Report Inappropriate Content
@terziyski Thanks for the tip, but I don't have problems with DNS. My problem is configuring the DHCP addresses for the LAN Wifi users.
- Copy Link
- Report Inappropriate Content
@RichStaf Maybe I should explain again. The WR902AC will only be used for wifi clients. I want the wifi clients to have their own subnet and these addresses to be given out by the DHCP server configured on the WR902AC itself. The WAN IP address of the WR902AC will be a different IP address obtained from the DHCP server on the WAN network. In other words, the WR902AC would perform NAT. What is the best way to configure this ?
- Copy Link
- Report Inappropriate Content
WR902AC does NAT in two of its working modes - router mode and hotspot mode (WISP mode).
Depending on how you connected it to your main router (wired or wireless) choose WR902AC mode accordingly.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1243
Replies: 9
Voters 0
No one has voted for it yet.