Connection preferences not appearing for clients on M5 latest firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connection preferences not appearing for clients on M5 latest firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connection preferences not appearing for clients on M5 latest firmware
Connection preferences not appearing for clients on M5 latest firmware
2023-07-24 08:47:11 - last edited 2023-07-25 03:01:18
Model: Deco M5   Deco E4  
Hardware Version: V1
Firmware Version: 1.7.1 Build 20230608 Rel. 74023

Upgraded to latest firmware to use the much needed connection preferences for clients, only to find the option doesn't seem to be there. I am using version 3.4.25 of the app on android

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Connection preferences not appearing for clients on M5 latest firmware-Solution
2023-07-24 13:14:54 - last edited 2023-07-25 03:01:18

  @Zoddy 

 

Deco E4 firmware does not support connection preference. You will see this option appear in Deco app only when all Deco units support it.

 

If you wish, you can run the test: delete in Deco app all E4s from your Deco mesh, leave just M5s. After that, you should see connection preference options appear in Deco app.

 

 

Recommended Solution
  3  
  3  
#4
Options
3 Reply
Re:Connection preferences not appearing for clients on M5 latest firmware
2023-07-24 12:28:15

  @Zoddy 

 

Do you have only M5s in your Deco mesh?

  0  
  0  
#2
Options
Re:Connection preferences not appearing for clients on M5 latest firmware
2023-07-24 12:33:28

  @Alexandre. No, I've got 2 M5's and 3 E4's

  0  
  0  
#3
Options
Re:Connection preferences not appearing for clients on M5 latest firmware-Solution
2023-07-24 13:14:54 - last edited 2023-07-25 03:01:18

  @Zoddy 

 

Deco E4 firmware does not support connection preference. You will see this option appear in Deco app only when all Deco units support it.

 

If you wish, you can run the test: delete in Deco app all E4s from your Deco mesh, leave just M5s. After that, you should see connection preference options appear in Deco app.

 

 

Recommended Solution
  3  
  3  
#4
Options