Access Point not connect

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Access Point not connect

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Access Point not connect
Access Point not connect
2023-07-18 05:40:10
Model: TL-WA801ND  
Hardware Version: V5
Firmware Version:

Access point not getting connected. not even wireless password accepted.

 

  0      
  0      
#1
Options
1 Reply
Re:Access Point not connect
2023-07-27 01:35:42

  @SachinGhawre 

 

Hi, which working mode are you trying to use? Access Point, Repeater or Client mode?

Please reset the device to factory defaults by holding reset button/hole for about 10s until power LED flashing. Then please check if you will be able to connect it via the default wireless password, and set it up successfully.

How to configure Access Point mode of the Wireless N Access Point

How to configure Client mode of the Wireless N Access Point

How to configure Repeater mode of the Wireless N Access Point

How to configure Multi-SSID mode of the Wireless N Access Point

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options