Home

Forums

Stories

Knowledge Base

Home Network Community > Range Extenders > Connecting the RE305 Range Extender to the NighthawkMR6110 Router

< Range Extenders

Connecting the RE305 Range Extender to the NighthawkMR6110 Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connecting the RE305 Range Extender to the NighthawkMR6110 Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Mogilla

2023-07-12 02:49:25

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-07-12

Connecting the RE305 Range Extender to the NighthawkMR6110 Router

2023-07-12 02:49:25

Tags: #Feature Request #Access Control #Access Point Mode

Model: RE305

Hardware Version:

Firmware Version:

I cannot get the Range Extender and the Router to connect. The Router is allowing my Laptops (X2) and iPhones (x2) to connect but as of yet cannot use the Range Extender so we are huddled around the router. I am following the Quick Istallation Guide and the App - but I must admit not too confidentally.

1 Reply

David-TP

2023-07-13 08:15:03

Posts: 12857

Helpful: 1810

Solutions: 1298

Stories: 9

Registered: 2020-04-14

Re:Connecting the RE305 Range Extender to the NighthawkMR6110 Router

2023-07-13 08:15:03

@Mogilla

Hi, Thanks for the feedback.

NighthawkMR6110 is a wifi 6 router and you could check whether you might have set up the security to WPA3 only since RE305 does not support WPA3.

After that, it is suggested to refer to the following link and check whether NighthawkMR6110 has configured the same settings.

Thank you very much.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.

Connecting the RE305 Range Extender to the NighthawkMR6110 Router

Connecting the RE305 Range Extender to the NighthawkMR6110 Router

Information

Voters 0

Tags