Hi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Hi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi
Hi
2023-05-18 19:58:19 - last edited 2023-05-26 22:02:32
Model: TL-WA850RE  
Hardware Version: V5
Firmware Version: 1.0.0 Build 20181107 Rel. 73626

Hi

Caption

 I can't access the device settings, I forgot the passcode

  0      
  0      
#1
Options
1 Accepted Solution
Re:Hi-Solution
2023-05-26 22:02:13 - last edited 2023-05-26 22:02:32

  @Sunshine   Thank you very much, the problem is solved

Sunshine wrote

  @goran79 

 

Hi, please try admin in lower case, if it doesn't work and you cannot recall any other possible password, please reset the extender to factory defaults: With the extender powered on, use a pin to press the RESET button for 1 second. The extender will reboot.

 

After that, please set up the extender again.

 

Recommended Solution
  1  
  1  
#4
Options
3 Reply
Re:Hi
2023-05-18 19:59:14
لا يمكنني الوصول إلى إعدادات الجهاز ، لقد نسيت رمز المرور
  0  
  0  
#2
Options
Re:Hi
2023-05-19 02:34:09

  @goran79 

 

Hi, please try admin in lower case, if it doesn't work and you cannot recall any other possible password, please reset the extender to factory defaults: With the extender powered on, use a pin to press the RESET button for 1 second. The extender will reboot.

 

After that, please set up the extender again.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#3
Options
Re:Hi-Solution
2023-05-26 22:02:13 - last edited 2023-05-26 22:02:32

  @Sunshine   Thank you very much, the problem is solved

Sunshine wrote

  @goran79 

 

Hi, please try admin in lower case, if it doesn't work and you cannot recall any other possible password, please reset the extender to factory defaults: With the extender powered on, use a pin to press the RESET button for 1 second. The extender will reboot.

 

After that, please set up the extender again.

 

Recommended Solution
  1  
  1  
#4
Options