Home Network Community > Wi-Fi Routers > C80 Max number of routers or nodes in OneMesh set up
< Wi-Fi Routers

C80 Max number of routers or nodes in OneMesh set up

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

C80 Max number of routers or nodes in OneMesh set up

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
C80 Max number of routers or nodes in OneMesh set up
C80 Max number of routers or nodes in OneMesh set up
2023-05-04 15:14:24 - last edited 2023-05-05 01:24:13
Tags: #OneMesh #Just_because_it_can_work
Model: Archer C80  
Hardware Version: V2
Firmware Version: 1.12.10 Build 230208 Rel.38553n(4555)

hi there,

 

Who of TP can answer this question? laugh

 

 

Tia,

 

Thom

  0      
 
  0      
 
#1
Options
3 Reply
Re:C80 Max number of routers or nodes in OneMesh set up
2023-05-04 22:35:18

  @Thom_NL 

 

Check this link - just before the Q&A section.

" *Only one router is needed to build Mesh networks. OneMesh™ supports up to six OneMesh™ devices, including the router. "

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  1  
  1  
#2
Options
Re:C80 Max number of routers or nodes in OneMesh set up
2023-05-05 06:22:09 - last edited 2023-05-05 06:23:48

@Terziyski,

 

That's the theoretical solution.

 

But just one router? I tested that and I have two C80 routers, one as main the other as node.

 

That's why I asked my question here on the community.

 

Nothing to the detriment of a help desk, but I can't get any further there.

 

 

Thanks and regards,

 

Thom

  0  
  0  
#3
Options
Re:C80 Max number of routers or nodes in OneMesh set up
2023-05-05 06:34:03 - last edited 2023-05-05 06:36:49

  @Thom_NL 

 

If you're using two C80 routers then you've built an EasyMesh network.

Given that the two technologies are similar, my educated guess would be that the same limit for the nodes number is valid.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 852

Replies: 3

Tags

OneMesh
Just_because_it_can_work
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.