WAN Speed Issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WAN Speed Issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WAN Speed Issue

Uswatun12

2023-05-01 12:04:35

Posts: 2

Helpful: 3

Solutions: 0

Stories: 0

Registered: 2023-05-01

WAN Speed Issue

2023-05-01 12:04:35

Tags: #Bandwidth Control/QoS

Model: Archer C54

Hardware Version: V1

Firmware Version: V1_1.12.0 Build 221216

I set the limiter on the wan to 10mbps full-duplex, but the internet coming out is only 1.2mbps.

if i use 10mbps half-duplex the internet comes out only 7.6mbps and the ping latency is very high.

please fix this problem, because this router cannot use bandwidth control.

1 Reply

Kevin_Z

2023-05-05 11:48:55

Posts: 21750

Helpful: 5128

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:WAN Speed Issue

2023-05-05 11:48:55

Hello @Uswatun12

If the internet speed is not as good as expected, please help verify some details, then we will see how to proceed.

How much bandwidth did you pay for the internet? Is it 10mbps? What is the speed you can get if you connect a computer to the modem which is provided by your ISP? Please keep in mind that the total bandwidth you can get from the router can exceed that you can get from the ISP-provided modem.

If the speed is good as expected when connecting a computer to the ISP-provided modem, please reset the C54 to factory defaults, then reconfigure it from scratch. This time don't modify or change any advanced settings such as QoS, leave all by default. When getting online, please test the speed again.

Here are some more troubleshooting suggestions that you can try if the speed is still not good.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

WAN Speed Issue

WAN Speed Issue

Information

Voters 0

Tags