M5 Manual Signal Source not working
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
M5 Manual Signal Source not working
Tags:
#Access Point Mode
#Manual Signal Source
I have a main deco and 2 satellites: A, B.
I want them to connect in a star-topology: A <- Main -> B, but I'm keep getting the following topology: Main -> A -> B.
I tried defining B's connection preference to be Main, but that setting only applies for about 15 minutes after a reboot, and the wrong topology comes back- B connects to A.
I tried to reinstall the entire network but the problem persists.
I think this issue started after the last firmware update, but I'm not sure.
Any help or suggestions on this?