Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Deco X20 with FTTP

< Deco

Deco X20 with FTTP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X20 with FTTP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X20 with FTTP

topgazza1

2023-04-20 21:36:39 - last edited 2023-04-21 08:15:32

Posts: 16

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2021-05-19

Deco X20 with FTTP

2023-04-20 21:36:39 - last edited 2023-04-21 08:15:32

Model: Deco X20

Hardware Version: V3

Firmware Version:

I think I've worked it out but as always I feel safer checking with the community here.

I have 3x Deco X20s through the house connected in AP mode to my ISP supplied router. I did experiment with WiFi router mode but the ISP router didn't like it. However I've been told that I will soon get fibre to my house via Openreach (UK). I understand I can plug my main X20 direct into the ONT. I assume changing to router mode ?

That leaves me with no LAN so do I use the second port on the main X20 into a switch and then onto my LAN setup ?

1 Accepted Solution

David-TP

2023-04-21 02:55:32 - last edited 2023-04-21 08:15:32

Posts: 12775

Helpful: 1790

Solutions: 1294

Stories: 9

Registered: 2020-04-14

Re:Deco X20 with FTTP-Solution

2023-04-21 02:55:32 - last edited 2023-04-21 08:15:32

@topgazza1

Hi, Yes, after switching to fiber, Deco X20 could be connected to ONT directly and work in wireless router mode.

And the second port of Deco X20 could be used to connect a network switch to provide more Ethernet connection.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.

Recommended Solution

2 Reply

David-TP

2023-04-21 02:55:32 - last edited 2023-04-21 08:15:32

Posts: 12775

Helpful: 1790

Solutions: 1294

Stories: 9

Registered: 2020-04-14

Re:Deco X20 with FTTP-Solution

2023-04-21 02:55:32 - last edited 2023-04-21 08:15:32

@topgazza1

Hi, Yes, after switching to fiber, Deco X20 could be connected to ONT directly and work in wireless router mode.

And the second port of Deco X20 could be used to connect a network switch to provide more Ethernet connection.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.

Deco X20 with FTTP

Deco X20 with FTTP

Information

Voters 1

Tags