DSL packet errors
I switched from old dsl modem to DECO X50-dsl. I never had problems with my dsl connection. But with this modem connection lags a deco shows high packet loss. I think that the problem is in bad SNR margin but there is no option to tweak it in deco settings. SRA and bitswap do not help. Do you have any advice?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
May I know the model number of your DSL service provider?
Could you please refer to this link to help me check the DSL sync status on Deco X50-DSL:
How to check DSL sync status on Deco DSL model
As for the "modem connection lags a deco shows high packet loss", can I have more details about it, maybe with some ping test results?
Wait for your reply.
best regards.
- Copy Link
- Report Inappropriate Content
I am not sure what ISPs model number means.
My ISP is Vodafone but DSL owner/maintainer is CETIN.
DSL is unstable mainly in the evening. Probably because of hight DSL line load. I tried turning bitswap and sra on and off but it makes no difference.
Previously i had Comtrend vr-3031eu and i never had expirienced internet problems. I switched to deco for 5 ghz wifi and gbit ethernet ports.
From DECO app:
- Copy Link
- Report Inappropriate Content
Thanks for the feedback.
I would like to follow up on your case via email. Please check whether you have got an email from me.
Best regards.
- Copy Link
- Report Inappropriate Content
Hello,
my problem is exactly the same after replacing the Archer VR2800 modem with a DECO x50-DSL. After setting up vdsl2 synchronization occurs, but after a few hours a packets error occurs and connectivity degrades, resetting from any dsl parameter does not help, only restarting the modem and resynchronizing with dslam.
And then the situation repeats itself until the device is restarted again
DSL
Line Status:
Connected
DSL Up Time:
0 days 6 hours 42 minutes
DSL Modulation Type:
VDSL2
Annex Type:
Annex auto
Current Rate (up/down):
27263/132879kbps
Max Rate (up/down):
34065/152587kbps
SNR Margin (up/down):
10/7dB
Line Attenuation (up/down):
1/7dB
Errors (up/down):
0/1113pkts
- Copy Link
- Report Inappropriate Content
@AdisNorbis Thank you very much for the feedback.
Could you please provide more details about "connectivity degrades"? Did it more refer to the network speed or internet stability?
May I know who is your internet service provider?
Did you have a similar issue on the Archer VR2800 before?
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
Hello,
connectivity degradation, as a gradual decrease in speed with an increase in packet loss to the utility of the traffic to begin with. Replaced the cable today with a definitely new Belden, but the problem with the increase and decrease in speed remains. The Archer VR 2800 has never exhibited this situation. Unfortunately, the Archer VR2800 is no longer functional, hence the replacement. To be sure, tested on the Archer VR2100 modem, where the problem also appears-tested on all available FW from iNet. connectivity is from T-Mobile Czech Republic, but the shared HW network rDslam CETIN I assume about Huawei
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 875
Replies: 6
Voters 0
No one has voted for it yet.