Home Network Community > Wi-Fi Routers > WiFi switch (on/off) difficult to actuate.
< Wi-Fi Routers

WiFi switch (on/off) difficult to actuate.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WiFi switch (on/off) difficult to actuate.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WiFi switch (on/off) difficult to actuate.
WiFi switch (on/off) difficult to actuate.
2023-02-13 18:47:12 - last edited 2023-02-15 23:35:04
Tags: #WiFi switch (on/off)
Model: Archer C7  
Hardware Version: V2
Firmware Version: 3.15.3 Build 180114 Rel.39265n

I have a TP-LINK AC1750 C7 V2 that I'm using as an access point and I would like to disable the Wifi. 
It turns out that it is not possible in the settings, to disable the Wifi I need to activate a switch (on/off) that is close to the power button. It turns out that the switch (on/off) in question is hard, that is, stuck. Is it difficult to to move the key or is it a defect?
Grateful for the attention.

  0      
 
  0      
 
#1
Options
2 Accepted Solutions
Re:WiFi switch (on/off) difficult to actuate.-Solution
2023-02-14 16:58:45 - last edited 2023-02-15 23:35:04

  @webipsum 

 

Yes, it did (but not so smoothly) when I owned this HW v2:

 

Try to put some more pressure when sliding it. There's a little gap on the button itself, which you can use for a better grip - use a pin, paperclip, etc.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  1  
  1  
#6
Options
Re:WiFi switch (on/off) difficult to actuate.-Solution
2023-02-15 23:32:45 - last edited 2023-02-15 23:35:07

terziyski wrote

  @webipsum 

 

Try to put some more pressure when sliding it. There's a little gap on the button itself, which you can use for a better grip - use a pin, paperclip, etc.

  @terziyski 
I opened the router and worked with a small screwdriver, on the base of the switch and not on the tip.
With that I was able to move the switch. Wifi is now off.
I tried to move the switch by acting on the end, as before, WITHOUT SUCCESS.
That is, to turn it on and off just by acting on the base of the switch and not on the tip.
Thanks for your help.

Recommended Solution
  0  
  0  
#7
Options
6 Reply
Re:WiFi switch (on/off) difficult to actuate.
2023-02-14 03:21:33

@webipsum 

 

Hi,

 

Do you mean the Wi-Fi ON/OFF switch on your device is broken?

 

Are you still able to disable the Wi-Fi on the router web management page? You can go to Wireless 2.4GHz and Wireless 5GHz, then uncheck the Enable SSID Broadcast as follows:

If my reply helps with the issue, please click on the arrow pointing upward. If it solves your issue, please click the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options
Re:WiFi switch (on/off) difficult to actuate.
2023-02-14 11:03:19

  @Liverpool20 

Hi.
Thanks for your response.
I don't know if the key is broken. It has never been used. Now that I've tried using it, I can't move it left or right, or should I press it?
I had unchecked Enable SSID Broadcast on both bands.
My question is that the Wifi led remains lit on the front leds of the router.
So I understood that the frequencies are still being made available.
I want to avoid conflict with Wifi from Mesh devices.
Best regards.

  0  
  0  
#3
Options
Re:WiFi switch (on/off) difficult to actuate.
2023-02-14 12:51:57 - last edited 2023-02-14 16:49:08

  @webipsum 

 

Disabling SSIDs broadcast just stops broadcasting their name (SSIDs). To disable the wireless radio you have to use the button on the back of the router:

 

This button (for Archer C7 v2) should be slid left or right:

 

 

Here's a guide on that matter.

 

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  1  
  1  
#4
Options
Re:WiFi switch (on/off) difficult to actuate.
2023-02-14 13:53:37 - last edited 2023-02-14 14:27:21

  @terziyski 

So... the key is stuck, I can't switch.
Does your Wifi switch slide smoothly between on and off?

  0  
  0  
#5
Options
Re:WiFi switch (on/off) difficult to actuate.-Solution
2023-02-14 16:58:45 - last edited 2023-02-15 23:35:04

  @webipsum 

 

Yes, it did (but not so smoothly) when I owned this HW v2:

 

Try to put some more pressure when sliding it. There's a little gap on the button itself, which you can use for a better grip - use a pin, paperclip, etc.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  1  
  1  
#6
Options
Re:WiFi switch (on/off) difficult to actuate.-Solution
2023-02-15 23:32:45 - last edited 2023-02-15 23:35:07

terziyski wrote

  @webipsum 

 

Try to put some more pressure when sliding it. There's a little gap on the button itself, which you can use for a better grip - use a pin, paperclip, etc.

  @terziyski 
I opened the router and worked with a small screwdriver, on the base of the switch and not on the tip.
With that I was able to move the switch. Wifi is now off.
I tried to move the switch by acting on the end, as before, WITHOUT SUCCESS.
That is, to turn it on and off just by acting on the base of the switch and not on the tip.
Thanks for your help.

Recommended Solution
  0  
  0  
#7
Options

Information

Helpful: 0

Views: 1283

Replies: 6

Tags

WiFi switch (on/off)
Related Articles
WDS Switch Archer C7
1228 1
No wifi when router is on switch
1102 0
 Wifi switch off/on
233 2
Using a wi-fi satellite router as a wi-fi extender and a switch
188 0
Can I set my Archer VR400 v2 to work as a switch? (ethernet switch. no wifi)
670 0
 Devices connected to switch not seen by router
357 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.