What is Best layout and settings for Deco XE75?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

What is Best layout and settings for Deco XE75?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
What is Best layout and settings for Deco XE75?
What is Best layout and settings for Deco XE75?
2023-01-04 15:12:51 - last edited 2023-01-04 16:54:28
Model: Deco XE75  
Hardware Version:
Firmware Version:

Hello,

 

I recently purchased Deco XE75 (3 Packs).

 

my layout is:

 

fiber cable --- ISP Modem(router) ---ethernet to port 1---Main Deco.

 

Main Deco --- ethernet from ports 2,3 --- Deco2, Deco3.


Deco on Router Mode.

beamforming: activated

fast roaming: activated.

 

My internet speed is: Download 500 Mbs upload 250 Mbs.

 

unfortunately I didn't getting my full speed and internet drops randomly!

 

please advise.

 

  0      
  0      
#1
Options
2 Reply
Re:What is Best layout and settings for Deco XE75?
2023-01-05 06:14:06

  @iSalalah 

Hi, welcome to the community.

Is your current network layout like this:

I think you already have the best layout, and can I have more details of the network speed you have got from each Deco?

  • Please check the QOS settings and make sure it has been set to 1000m/s download and upload, or higher than your actual bandwidth.

As for the disconnection issue, have you noticed any Deco turned to flash red?

It is suggested to have a look at this link: Fix unstable connection when connected to the Deco network

Wait for your reply.

Best regards.

  1  
  1  
#2
Options
Re:What is Best layout and settings for Deco XE75?
2023-01-06 05:47:06

  @David-TP thank you for your help.

 

that was exactly what my network layout is. All settings as default and cables are fine as i used it before with other routers before I installed Deco system.

 

what i did now is switch from router mode to AP mode and seems deco are fine :), i want to give it some time to ensure this will  works well.

 

notice: when system was on router mode it created new network(not within ISP router IPs range 192.168.100.2/255), when switched to AP mode now taken and given devices IPs as ISP router. Not sure if i should setup static IP for main Deco from beginning to avoid this matter!

 

please advise 

  12  
  12  
#3
Options