This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
my device is DLINK DIR-825M HW: A1 (soc: RTL8367RB)
i want to get U-BOOT ... because it breaked :(
i contact to D-LINK but no support :( really no support)..
i only want to re flash it with the origin firmware but no boot on it...
Serial Info:
Booting...
init_ram
bond:0x00000005
MCM 128MB
dram_init_clk_frequency ,ddr_freq=1066 (Mbps), 533 (MHZ)
DRAM init disable
DRAM init enable
DRAM init is done , jump to DRAM
enable DRAM ODT
SDR init done dev_map=0xb8142000
Detect page_size = 2KB (3)
Detect bank_size = 8 banks(0x00000002)
Detect dram size = 128MB (0x08000000)
DDR init OK
init ddr ok
DRAM Type: DDR2
DRAM frequency: 533MHz
DRAM Size: 128MB
i want U-Boot
It seems you are asking in the wrong community. This is the TP-Link official community, it's not the D-LINK community.
Since your device model is D-LINK, you can ask for suggestions in their community.
Helpful: 0
Views: 488
Replies: 3
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
