Dropping speed on Wi-Fi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Dropping speed on Wi-Fi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dropping speed on Wi-Fi
Dropping speed on Wi-Fi
2022-11-23 22:21:44
Tags: #Wi-Fi
Model: Archer VR400  
Hardware Version: V1
Firmware Version: 0.1.0 0.9.1 v0070.0 Build 160613 Rel.40404n

Hi all, 

 

I have been struggling for a while now with the quality of my Wi-Fi connection. My connection tends to drop intermittently during Zoom calls and I have struggled to understand whether the issue is with my landline connection (FTTC ending in VDSL) or my Wi-Fi/powerline combo.

Tonight however whilst trying to figure out the issue I noticed that a major speed discrepancy when connecting to the TP-Link modem/router with Wi-Fi vs. Ethernet:

  • Ethernet straight to the laptop gives me roughly 45Mbps down / 16Mbps and the measurement is quite stable (through Ookla)
  • 2.4GHz Wi-Fi gives me roughly 15Mbps / 10Mbps with the speed oscillating quite a bit during measurement.

 

To avoid introducing any interference or signal attenuation I tested Wi-Fi whilst standing right in front of the router... despite that the speed measured is still a far cry from what my VDSL provides me with. 

 

I have tested different channels to no avail. Overall my local airwaves are not that busy. See screenshot of WiFi Explorer below with my network in bold:

 

A ping test (as per ) also shows regular high latency spikes. See screenshot of a relatively good run (Ethernet is a lot more stable again):

 

Any idea what my be causing the speed drop? It is surprisingly bad given how far I am from the theoritical limits of 2.4GHz Wi-Fi.

 

Many thanks in advance!

  0      
  0      
#1
Options
1 Reply
Re:Dropping speed on Wi-Fi
2022-11-25 11:07:18

  @MacFr Hi, I always had a feeling that 2.4 GHz Wi-Fi is easily interrupted by all kinds of interference. If you could use 5ghz, try to stay on 5ghz for live audio/video calling

And I see channel 6 is less occupied, I think you can try to change VR400 to channel 6 and also set the bandwidth to 40mhz.

 

  0  
  0  
#2
Options