WebAdmin - Configuration Slow

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WebAdmin - Configuration Slow

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ashbashar

2022-11-16 15:19:19

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-11-16

WebAdmin - Configuration Slow

2022-11-16 15:19:19

Model: Archer C60

Hardware Version:

Firmware Version:

COnfiguration page (Webadmin) very slow :

Firmware uto date

Several reboot was completed

Several Browsers were tried

Several different machines were connected from MAc and PC

Both wired and Wireless tried

The configuration page is very slow takes ages to load if it ever loads that is and not timeout.

I know there has been previous dicussion about this but coudnt find a solution to it, other than getting rid of and go back to netgear

1 Reply

woozle

LV6

2022-11-16 20:45:07 - last edited 2022-11-16 20:45:45

Posts: 3252

Helpful: 2109

Solutions: 649

Stories: 0

Registered: 2020-05-01

Re:WebAdmin - Configuration Slow

2022-11-16 20:45:07 - last edited 2022-11-16 20:45:45

@ashbashar

Hi,

You could try the following:

Perform a "Factory Default Restore", either via the configuration page (Advanced tab -> System Tools -> Backup & Restore) or by pressing and holding the Reset button for at least 5 seconds (until you notice some special response from the LEDs).

Connect only one client device to the C60 (to be sure unplug all other Ethernet cables from the router) and then open the configuration page. Check if it's still responding slowly.

WebAdmin - Configuration Slow

WebAdmin - Configuration Slow

Information

Voters 0

Tags