RE200 powers off after few seconds (faulty firmware update)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
hello,
while doing a manual update for my extender ( just out of warranty) over wifi (big mistake on my part) it powered off....
now when i plug it in it starts to power up then only the power LED stays green for a few seconds then power off, tried the reset button without any result...
any way to recover from this catastrophe?
NB.
I have some experience with flashing IoT devices via serial connection and after researching i found an after market firmware site detailing the serial flash process for their firmware and the pinout for the RE200... in desperation i opened the device and soldered the connectors but i got no where as the device wont stay on for more than a couple of seconds
is there a similar recover process with the official firmware? ar is the device trashed?
