M4R Bootloop after a firmware recovery was done

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

M4R Bootloop after a firmware recovery was done

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Kyubei

2022-10-23 13:23:53

Posts: 6

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-09-09

M4R Bootloop after a firmware recovery was done

2022-10-23 13:23:53

Tags: #Firmware Update #Access Point Mode #Feature Request

Model: Deco M4

Hardware Version: V3

Firmware Version: 1.5.1

After I did a firmware recovery on my deco M4R it keeps flashing yellow after a successful firmware upgrade even though it was successful it keeps flashing yellow. I hope this can be fixed. ty

1 Reply

Heidi_Alp

LV3

2022-10-26 03:32:05

Posts: 280

Helpful: 95

Solutions: 17

Stories: 6

Registered: 2021-07-16

Re:M4R Bootloop after a firmware recovery was done

2022-10-26 03:32:05

@Kyubei

You could power off Deco for about 5-10mints, then hold the reset pinhole for 1s again. If still blinking yellow all the time, it's time to ask for a replacement.

M4R Bootloop after a firmware recovery was done

M4R Bootloop after a firmware recovery was done

Information

Voters 0

Tags