Archer AX50 LED Control in access point mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer AX50 LED Control in access point mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer AX50 LED Control in access point mode
Archer AX50 LED Control in access point mode
2022-09-25 15:29:10
Model: Archer AX50  
Hardware Version: V1
Firmware Version: 1.0.11 Build 20210730 rel.54485

Hi,

 

Is there a way to enable the "night mode" with an Archer AX50 in "access point" mode, please ? 

 

According to the manual, this feature is available in the "Advanced > System Tools > LED Control" screen.

 

But, if I'm not mistaken, the "advanced menu" is not a not available in "access point" mode...

 

Best regards,

Christophe

  0      
  0      
#1
Options
1 Reply
Re:Archer AX50 LED Control in access point mode
2022-09-25 16:12:03 - last edited 2022-09-25 16:15:27

  @Chris_FR 

 

Once configured, LED control should still work, after the device mode has been changed to AP:

" At last, the other functions supported by both Router Mode and Wireless Access Point Mode, including Led Control, Auto Reboot, Time Settings, USB Sharing and Wi-Fi Schedule, would still keep alive after changing modes. "

Here's a guide on differences between router mode and AP mode.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options