USB Storage device - Not showing the right ip address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

USB Storage device - Not showing the right ip address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MDavid

2022-09-22 20:08:12

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-09-22

USB Storage device - Not showing the right ip address

2022-09-22 20:08:12

Tags: #USB Sharing

Model: Archer AX50

Hardware Version: V1

Firmware Version: 1.0.11 Build 20210730 rel.54485(5553)

Hi every one

I can't acces my USB Sharing device from outside. In my config, the FTP(via Internet) is not showing the right IP. My local FTP is : ftp://192.168.0.1:21, but the other show : ftp://192.168.2.10:2121 My router is connected on my Bell internet that is also a router. So i think that my archer is only viewing the IP from the Bell Router. Do you have any advice for me ?

Thanks.

1 Reply

terziyski

LV7

2022-09-22 20:27:12 - last edited 2022-09-22 20:31:14

Posts: 7141

Helpful: 5351

Solutions: 1220

Stories: 7

Registered: 2013-10-12

Re:USB Storage device - Not showing the right ip address

2022-09-22 20:27:12 - last edited 2022-09-22 20:31:14

@MDavid

You probably are behind a double NAT because of the two routers in series.

A possible solution is to use the Bell Router in bridge pome (if possible) to avoid teh double NAT and receive your public IP address on the AX50 WAN port.

If that's not possible you can configure AX50 in AP mode (Case 1), which should avoid the double NAT as well.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

USB Storage device - Not showing the right ip address

USB Storage device - Not showing the right ip address

Information

Voters 0

Tags