Two RE700X, one in mode AP, the other in Extender, OneMesh cannot be enabled!
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hey Guys
I have two RE700X, one in AP Mode, the other in Repeater mode, why is it not possible to enable OneMesh?
I have a custom router and the RE700X in AP mode is cabled, any ideas?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello @MrPeralta
Thank you for the feedback, so far the TP-Link range extenders do not support OneMesh in AP mode and here is a related topic.
Feature request post: [Range Extender] OneMesh Supports Ethernet Backhaul
This Mesh Ethernet backhaul feature might be achieved by EasyMesh, while as that is in Planned stage there is no guarantee.
Here is another thread that you may be interested in:
EasyMesh Networking: Build Wireless Backhaul between Routers and Range Extenders
- Copy Link
- Report Inappropriate Content
Thank you for your reply, although it doesn't make much sense as it why it behaves like this.. it is what it is.
On another thing, would it be possible to release source code on the RE700X , if one could port another firmware (and depending on the chipset), it could support 802.11s
- Copy Link
- Report Inappropriate Content
Another thing, the GPL code for this AP should be released, it's basically an openwrt (reversed it) , based on 15.05 (kind of old but yeah)
- Copy Link
- Report Inappropriate Content
If you are interested in the source code subject to the GPL, please contact us under GPL@tp-link.com.
For more details, please check GLP code data center here
https://www.tp-link.com/support/gpl-code/
Hope this helps~
- Copy Link
- Report Inappropriate Content
And regarding the initial question.
Is it possible to get a OneMesh supported router, but have it to act just as a dumb switch? I don't want it managing any kind of network/nat/routing, I just need the OneMesh functionality to work
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1417
Replies: 5
Voters 0
No one has voted for it yet.